Operating instructions for RTSP streaming after the computer connects to the G1 camera module WiFi

The G1 camera module is a full-featured camera module combination developed by Huaxing Video based on the V39M chip of iCatch Technology, including the camera core motherboard,Camera module, a WIFI expansion board/network expansion board can be added according to needs.The G1 camera module with the wifi expansion board supports the rtsp protocol. You can use a computer to connect to the camera module's wifi to pull rtsp streams. The following are the specific steps:

1. After the G1 camera module is turned on, turn onWiFi（WiFiOn the boardWiFiThe indicator light flashes red);

If you are using the G1-W-V3.0 wifi board,When the camera module is powered on, short press the Wifi button on the Wifi board to turn the Wifi function on and off;

If you are using the G1-W-V6.3 wifi board,When the camera module is powered on,You can press and hold the motherboard's shooting button for 3 seconds, turn the Wifi function on and off.

▲G1-W-V3.0 wifi expansion board

▲G1-M-V6.2 camera motherboard

2. Connect the computer to the G1 camera moduleWiFi,like:G1A0_XXXX, the default wifi password is: 12345678, computer connectionWiFiAfter success, the indicator light on the wifi board turns red and stays on;

3. Callcmd Enter the commandping192.168.1.1 Check whether the communication is working. As shown in the figure below, it is displayedpingAccess to the Internet;

4. Open the installedPotPlayerPlayer, click the upper left corner to open the main menu drop-down list, move the mouse to open and then move to the list on the right, left-click "Open Link", enter the address "rtsp://192.168.1.1:554/H264?W=1280&H=720&BR=2000000&FPS=30",Then select OK to display the image of the current camera module.